# ESP8266 Lua/NodeMCU module for MAX44009 illuminance sensor This repository contains an ESP8266 NodeMCU Lua module (`max44009.lua`) as well as MQTT / HomeAssistant / InfluxDB integration example (`init.lua`) for **MAX44009** illuminance sensors. ## Dependencies max44009.lua has been tested with Lua 5.1 on NodeMCU firmware 3.0.1 (Release 202112300746, float build). It requires the following modules. * bit * i2c Most practical applications (such as the example in init.lua) also need the following modules. * gpio * mqtt * node * tmr * wifi ## Setup Connect the MAX44009 sensor to your ESP8266/NodeMCU board as follows. * MAX44009 GND → ESP8266/NodeMCU GND * MAX44009 VCC → ESP8266/NodeMCU 3V3 * MAX44009 SDA → NodeMCU D1 (ESP8266 GPIO5) * MAX44009 SCL → NodeMCU D2 (ESP8266 GPIO4) If you use different pins for SCL and SDA, you need to adjust the i2c.setup call in the examples provided in this repository to reflect those changes. Keep in mind that some ESP8266 pins must have well-defined logic levels at boot time and may therefore be unsuitable for MAX44009 connection. ## Usage Copy **max44009.lua** to your NodeMCU board and set it up as follows. ```lua max44009 = require("max44009") i2c.setup(0, sda_pin, scl_pin, i2c.SLOW) -- can be called with up to 1 Hz function some_timer_callback() local lx = max44009.read() if lx == nil then print("MAX44009 error") else -- lx contains the illuminance. Note that it is a floating point value. end end ``` ## Application Example **init.lua** is an example application with HomeAssistant integration. To use it, you need to create a **config.lua** file with WiFI and MQTT settings: ```lua station_cfg = {ssid = "foo", pwd = "bar"} mqtt_host = "..." ``` Optionally, it can also publish readings to InfluxDB. To do so, configure URL and attribute: ```lua influx_url = "..." influx_attr = "..." ``` Readings will be stored as `max44009[influx_attr] illuminance_lx=...`. So, unless `influx_attr = ''`, it must start with a comma, e.g. `influx_attr = ',device=' .. device_id`.